Chrysler Concorde 1993 Service Manual page 634

Fig. 21 Remove No. 1 Caged Needle Bearing
Fig. 22 Remove Input Clutch Assembly
Fig. 23 Remove Front Sun Gear Assembly
Fig. 24 Remove Front Carrier and Rear Annulus
Assembly
Fig. 25 Remove Rear Sun Gear
The number 7 needle bearing that was removed
must not be reversed when reinstalling. This bearing
is visually similar to the number 2 and 5 bearings
but it is unique to the number 7 position. It is rec-
ommended that the number 7 thrust bearing be indi-
vidually tagged after removing. This will eliminate
the possibility of installing the incorrect bearing in
the number 7 bearing position.
The number 7 bearing must be installed so that
the inside diameters elbow flange is seated against
the rear sun gear (Fig. 26). A small amount of petro-
latum can be used to hold the bearing to the rear sun
gear.
21 - 35