Chrysler Concorde 1993 Service Manual page 309

Fig. 3 Horn and Connector
Fig. 4 Horn Switch
HORN RELAY REPLACEMENT
(1) Open driver's door and remove instrument end
cover.
(2) Remove horn relay (Fig. 5).
(3) For installation, reverse above procedures.
HORN REPLACEMENT
(1) Disconnect connector and remove horn mount-
ing bolt.
(2) For installation, reverse above procedures.
Fig. 5 Horn Relay Location
HORN SWITCHES REPLACEMENT
WARNING: BEFORE BEGINNING ANY AIRBAG SYS-
TEM REMOVAL OR INSTALLATION PROCEDURES,
REMOVE AND ISOLATE THE NEGATIVE (-) BAT-
TERY CABLE (GROUND) FROM THE VEHICLE BAT-
TERY. THIS IS THE ONLY SURE WAY TO DISABLE
THE AIRBAG SYSTEM. FAILURE TO DO THIS
COULD RESULT IN ACCIDENTAL AIRBAG DEPLOY-
MENT AND POSSIBLE PERSONAL INJURY.
(1) Disconnect and isolate negative battery cable
in engine compartment.
(2) Remove the two speed control switches or cover
plates from the steering wheel.
(3) Remove the screws that attach the driver air
bag module to the steering wheel.
(4) Lift the module to gain access and disconnect
the squib and horn wire.
(5) Place airbag module on a clean level surface
with pad facing upward.
(6) Push switch locking tab inward and remove
switch from module. Repeat for other switch.
(7) Disconnect the ground wire from the retainer
plate on the back side of the module. Bend the two
retainer tabs on the bracket to release the horn
switch wires.
(8) For installation, reverse above procedures. As-
sure that the switch is locked into position. Use cau-
tion not to pinch wires.
HORNS 8G - 3