Chrysler Concorde 1993 Service Manual page 152

5 - 58 BRAKES
Fig. 22 Park Brake Pedal Mechanism
Fig. 23 Correctly Installed Retaining Clip And
Assembled Cable
procedure in this section of the service manual
for complete parking brake adjustment proce-
dure.
5 PASSENGER MODELS
(1) Fold carpeting back into position on left floor pan
of vehicle. Install throttle pedal and bracket back on
dash panel studs and install attaching nuts.
(2) Install rear passenger compartment heat duct
(Fig. 26) back into vehicle. Install rear console assem-
bly mounting bracket (Fig. 26) on park brake cable
reaction bracket. Torque rear console assembly mount-
ing bracket to reaction bracket mounting bolts to 10
N¼m (88 in. lbs.).
Fig. 24 Front Park Brake Routing And Clipping
Locations
Fig. 25 Correct Park Brake Cable Routing At Pedal
Assembly
(3) Install drivers side cowl kick molding (Fig. 27).
Install drivers side door opening sill molding (Fig.
27).
(4) Install lower dash panel assembly back in vehi-
cle. Refer to Group 8 Electrical in this service manual
for required procedure to install lower dash panel.
(5) Install upper center console cover assembly
back in vehicle. Refer to Group 23 Body in this ser-
vice manual for required procedure to install upper
center console.
(6) Install shift knob on floor shifter (if equipped).
Shift knob is installed by pushing shift knob down
shift shaft until fully bottomed. Then install and
tighten 3/32 in. allen head set screw located on driv-
ers side of shift knob.
(7) Install drivers side seat assembly back in vehi-
cle. Refer to Group 23 Body in this service manual for
required seat, installation procedure.