Chrysler Concorde 1993 Service Manual page 89

Fig. 3 Tightening Wheel Nuts
INSTALL
(1) Install the stabilizer bar and isolator bushings
back into the vehicle as an assembly. Position stabi-
lizer bar so it is centered in the vehicle so it does not
contact other suspension components or vehicle body.
(2) Install the stabilizer bar attaching link onto
stabilizer bar. Install the stabilizer link to stabilizer
bar attaching nut (Fig. 2). Torque the stabilizer link
to stabilizer bar attaching nut to 95 N¼m (70 ft. lbs.).
(3) Install fuel tank back in vehicle. Refer to
Group 14 Fuel, in this service manual for the re-
quired fuel tank installation procedure.
CAUTION: The sway bar bracket bolts must be re-
placed after loosening or removing them. Only use
original equipment bolts as replacements.
the 4 crossmember to frame rail attaching bolts (Fig.
1). Torque the crossmember to frame rail attaching
bolts to 95 N¼m (70 ft. lbs.).
Tighten the wheel mounting stud nuts in proper se-
quence (Fig. 3) until all nuts are torqued to half
specification. Then repeat the tightening sequence to
the full specified torque of 129 N¼m (95 ft. lbs.).
tions if required.
SERVICING LATERAL LINKS
semblies. The isolator bushings used in the lateral
links are not serviced as separate components. The
left and right lateral links are serviced using differ-
ent procedures. See procedures below for the side of
the vehicle requiring service to the lateral links.
LEFT LATERAL LINKS
REMOVE
contact type hoist. See Hoisting in the Lubrication and
Maintenance section of this manual, for the required
lifting procedure to be used for this vehicle.
the vehicle.
links to the spindle (Fig. 2).
Fig. 1 Rear Suspension Lateral Links
SUSPENSION AND DRIVESHAFTS
(4) Position crossmember on frame rails and install
(5) Remove transmission jack supporting fuel tank.
(6) Install wheel and tire assembly on vehicle.
(7) Lower vehicle to the ground.
(8) Check and reset rear wheel TOE to specifica-
The lateral links are only serviced as complete as-
(1) Raise vehicle on jackstands or centered on a frame
(2) Remove left rear wheel and tire assembly from
(3) Remove the nut and bolt attaching left lateral
2 - 67