Chrysler Concorde 1993 Service Manual page 58

2 - 36 SUSPENSION AND DRIVESHAFTS
Fig. 6 Hub And Bearing Assembly Removal And
Installation
Fig. 7 Prying Hub And Bearing Assembly From
Steering Knuckle
Fig. 8 Hub And Bearing Assembly Mounting
Surfaces
CAUTION: The hub and bearing assembly to stub
shaft retaining nut (Fig. 10) is a prevailing torque
Fig. 9 Hub And Bearing Assembly Retaining Bolts
nut and can not be re-used. A NEW retaining nut
MUST be used when assembled.
(3) Install a NEW hub and bearing assembly to
stub shaft retaining nut (Fig. 10). Tighten, but do
not torque the hub nut at this time.
Fig. 10 Hub And Bearing To Stub Axle Retaining
(4) Install the braking disk back on the hub and
bearing assembly (Fig. 11).
(5) Install front brake caliper back over braking
disc and align with caliper mounting holes on steer-
ing knuckle (Fig. 12). Refer to Front Disc Brake Ser-
vice in the Brake Section of this service manual for
caliper installation procedure. Install the caliper
adapter to steering knuckle attaching bolts and
torque to 19 N¼m (168 in. lbs.).
(6) Install wheel and tire assembly on vehicle.
Tighten the wheel mounting stud nuts in proper se-
quence (Fig. 13) until all nuts are torqued to half
specification. Then repeat the tightening sequence to
the full specified torque of 129 N¼m (95 ft. lbs.).
(7) Lower vehicle to the ground.
Nut