Chrysler Concorde 1993 Service Manual page 746

Fig. 51 Door Latch Striker
(3) Using a fork-type
push-in fasteners holding weatherstrip to lower door
end frames and bottom panel.
(4) Separate primary weatherstrip from door.
INSTALLATION
(1) Place primary weatherstrip in position on door.
(2) Engage push-in fasteners to hold primary weath-
erstrip to lower door end frames and bottom panel.
(3) Insert weatherstrip into channel around upper
window frame.
(4) Verify weatherstrip seal.
Fig. 52 Door Primary Weatherstrip—Typical
REAR DOOR SECONDARY WEATHERSTRIP
REMOVAL (FIG. 53)
(1) Open rear door.
(2) Loosen door opening sill plate.
prying tool, disengage
(3) Pull secondary weatherstrip from fence around
door opening.
INSTALLATION
(1) Position splice in weatherstrip at center of door
opening sill.
(2) Push secondary weatherstrip onto fence around
door opening.
(3) Tighten door opening sill plate.
(4) Verify weatherstrip seal.
Fig. 53 Rear Door Secondary Weatherstrip
DRIP RAIL MOLDING
REMOVAL (FIG. 54)
(1) Release front door latch and open door.
(2) Release rear door latch and open door.
(3) Remove screws holding drip rail molding to
roof rail.
(4) Separate drip rail molding from vehicle.
Fig. 54 Drip Rail Molding
BODY 23 - 25