Chrysler Concorde 1993 Service Manual page 512

Fig. 4 Carpet and Insulation Placement
(3) Remove retainer clip from throttle cable and
grommet at dash panel (Fig. 2).
(4) From the engine compartment, pull the throttle
cable out of the dash panel grommet. The grommet
should remain in the dash panel.
(5) Remove the throttle cable from throttle bracket
by carefully compressing both retaining ears simulta-
neously. Then gently pull the throttle cable from
throttle bracket.
Fig. 5 Throttle Cable Removal/Installation—3.3L
Engine
Fig. 6 Throttle Cable Removal/Installation—3.5L
INSTALLATION
(1) From the engine compartment, push the hous-
ing end fitting into the dash panel grommet.
(2) Install the cable housing (throttle body end)
into the cable mounting bracket on the engine.
(3) From inside the vehicle, hold up the pedal and
install throttle cable and cable retainer in the upper
end of the pedal shaft.
(4) At the dash panel, install the cable retainer
clip between the end of the throttle cable fitting and
grommet (Fig. 2).
(5) From the engine compartment, rotate the throt-
tle lever to wide open and install the throttle cable.
On 3.5L engines, ensure the power steering hose is
routed through the hook on the throttle cable mount-
ing bracket (Fig. 7). Make sure the throttle cam and
power steering hose do not bind.
Fig. 7 Power Steering Hose and Bracket—3.5L
FUEL SYSTEMS 14 - 19
Engine
Engine