Chrysler Concorde 1993 Service Manual page 579

19 - 14 STEERING
INSTALL
Do not press or hammer on the shaft of the
power steering pump in an attempt to install the
pulley. This will damage the internal components
of the power steering pump.
(1) Place the power steering pump pulley on the end
of the power steering pump shaft. Make sure the pulley
is installed squarely on the end of the shaft (Fig. 3).
CAUTION: When installing the pulley on the Saginaw
T/C style power steering pump. The spacer that is
provided with either the replacement power steering
pump or pulley MUST be used when the pulley is
installed on the pump. The spacer provides for the
correct pulley location on the power steering pump to
provide correct accessory drive belt alignment. The
alignment is critical in controlling accessory drive
belt noise. It also prevents the pulley from contacting
the power steering pump when it is installed, causing
power steering pump or pulley damage.
(2) Install the spacer provided with the replacement
power steering pump or power steering pulley into the
hub of the power steering pump pulley (Fig. 3).
Fig. 3 Pulley And Spacer Installed On Pump
(3) Insert the Pulley Installer, Special Tool C-4063,
(without adapters) through hole in spacer. Then thread
it into the end of the power steering pump shaft (Fig.
4). Tighten the installer into shaft.
(4) Hold the Pulley Installer with one wrench so it
will not rotate. Turn hex (Fig. 4) down threaded rod of
installer pushing the pulley onto the shaft of the power
steering pump (Fig. 4). Ensure that the tool and the
pulley remain aligned with the pump shaft so pulley
does not become cocked on shaft.
(5) Continue to push pulley onto shaft of power
steering pump until Pulley Installer, Special Tool
C-4063 will no longer turn. This will ensure the
Fig. 4 Installing Power Steering Pump Pulley
spacer provided is fully seated against the front of
the power steering pump shaft (Fig. 5).
Fig. 5 Power Steering Pump Pulley Installed
(6) Remove the Pulley Installer, Special Tool
C-4063 from the shaft of the power steering pump.
Remove the supplied spacer from the hub of the
power steering pump pulley and discard.
POWER STEERING PUMP FLUID RESERVOIRS
The power steering pump fluid reservoir on the
L.H. platform vehicle is remotely mounted from the