Chrysler Concorde 1993 Service Manual page 251

Fig. 5 Starter—3.3L Engine
General Information . . . . . . . . . . . . . . . . . . . . . . . . 5
Generator Replacement—3.3L Engine
GENERAL INFORMATION
This section will cover generator replacement only.
Information covering generator on-vehicle testing and
diagnosis can be
Battery/Starting/Charging Systems Diagnostics. The
same Nippondenso 90 amp generator is used on both
the 3.3L and the 3.5L engines.
These generators are not intended to be disas-
sembled for service. It must be replaced as an
assembly.
GENERATOR REPLACEMENT—3.3L ENGINE
(1) Disconnect negative battery cable (Fig. 1).
(2) Disconnect the generator field circuit plug.
(3) Remove the B+ terminal nut and wire (Fig. 2).
(4) Loosen adjusting T-bolt, but do not remove (Fig.
3).
(5) Loosen pivot bolt, but do not remove.
(6) Remove the generator drive belt. Refer to Group
7, Cooling System.
(7) Remove adjusting T-bolt.
(8) Remove pivot bolt, being careful not to lose
spacer.
GENERATOR
. . . . . . . . . . 5
found in Group
BATTERY/STARTER/GENERATOR SERVICE
Fig. 6 Wire Terminal Connections
NEUTRAL STARTING AND BACK-UP SWITCH
For removal and installation of switch, refer to
Neutral Starting and Back-up Switch Replacement
in Group 21, Transaxle.
INDEX
page
Generator Replacement—3.5L Engine
8A,
Fig. 1 Remove negative battery (-) Cable
(9) Remove generator.
(10) For installation, reverse above procedures.
Tighten all fasteners to the proper torque. Refer to
the Torque Specifications chart at the rear Group 8A.
GENERATOR REPLACEMENT—3.5L ENGINE
(1) Disconnect negative battery cable (Fig. 1).
(2) Loosen lower mounting bolt do not remove (Fig.
4).
8B - 5
page
. . . . . . . . . . 5