Chrysler Concorde 1993 Service Manual page 380

8U - 2 CHIME WARNING/REMINDER SYSTEM
Fig. 2 Body Controller Location
(6) Tear the silencer pad at the gating and pull the
section back. A knife may be used to cut the gating if
required.
(7) Disconnect the body to instrument panel wiring
connector at the HVAC unit. Pull wire bundle out of
the way.
(8) Pull the body controller push pin out of the side
cowl.
(9) Rotate the body controller out from behind the
knee bolster.
To diagnose the body controller, connect the body
to instrument panel wiring connector at the HVAC
unit. Before installing the body controller, disconnect
the body to instrument panel wiring connector at the
HVAC unit.
INSTALLATION
(1) Ensure that the body controller push pin is in
good condition. If not, replace push pin.
(2) Connect the body controller wiring connectors.
(3) Rotate the body controller up behind the knee
bolster, guiding the wiring into the knee bolster
area.
(4) Insert the body controller push pin into the side
cowl.
(5) Rotate the body controller so that mounting
hole aligns with the hole in the side of the knee bol-
ster.
(6) Insert the mounting screw.
(7) Connect the body to instrument panel wiring
connector at the HVAC unit.
(8) Place the silencer pad back into place.
(9) Place the carpet back into place.
(10) Replace the right side heat distribution duct
under the instrument panel.
(11) Replace the side cowl trim panel.
(12) Replace the instrument panel end cover.
CHIME SYSTEM DIAGNOSIS
CONDITION
No tone when ignition switch is turned on and
drivers seat belt is unbuckled and fully retracted.
PROCEDURE
(1) Check driver's seat belt retractor switch for a
ground when belt is retracted.
(2) Use DRB II to perform CCD diagnostics on
body controller for battery and ignition and seat belt
switch input.
(3) Use DRB II to perform actuator diagnostics on
body controller chime.
(4) Check for battery feed at terminal J3-19 and
ignition feed at terminal J3-13 of body controller
(Fig. 3 and 4).
Fig. 3 Base Body Controller
Fig. 4 Premium Body Controller
(5) Check for tone in any other function.
CONDITION
No fasten seat belt lamp when ignition switch is
turned on.
PROCEDURE
(1) Use DRB II to perform CCD diagnostics on
body controller module for battery and ignition
switch input