Chrysler Concorde 1993 Service Manual page 657

21 - 58 TRANSAXLE
The reverse clutch pack clearance is 0.76 to
1.24 mm (.030 to .049 inch). Select the proper reverse
clutch snap ring to achieve specifications:
REVERSE CLUTCH SNAP RING CHART
All clutch clearances in the input clutch retainer
have now been checked and approved.
To complete the assembly of the input clutch re-
tainer, the reverse clutch and the overdrive clutch
must be removed from the retainer.
CAUTION: Do not intermix clutch parts. Keep in exact
same order.
Now proceed with the next phase of the assembly:
Fig. 31 Install No. 2 Needle Bearing
Now that both shaft assemblies and thrust washers
are properly installed, reinstall overdrive clutch and
reverse clutch as shown in Figures 20 through 28.
Rechecking these clutch clearances is not neces-
sary, as they were set and approved previously.
Fig. 32 Install Underdrive Shaft Assembly
Fig. 33 Install No. 3 Thrust Washer
Fig. 34 Install No. 3 Thrust Plate