8E - 6
INSTRUMENT PANEL AND GAUGES
(4) Remove four mask/lens retaining screws then
remove mask/lens.
(5) Remove tachometer and/or fuel/temperature
gauge from the cluster (Fig. 15).
Fig. 15 Gauge Removal
(6) For installation, reverse above procedures.
CLUSTER PRINTED CIRCUIT BOARD
REPLACEMENT
(1) Remove trip odometer reset knob by gently
pulling rearward.
(2) Remove cluster back cover retaining screws the
remove cover (Fig. 9 or 12).
(3) Disconnect transmission range indicator and
odometer connectors from the printed circuit board.
(4) Remove four printed circuit board retaining
screws. There are two screws located at the base of
each connector (Fig. 16 and 17).
Fig. 16 Print Circuit Board—Type A and C
Fig. 17 Print Circuit Board—Type B
(5) For installation, reverse above procedures.
CLUSTER BULB REPLACEMENT
Refer to Fig. 18 and 19 for appropriate lamp loca-
tions.
Fig. 18 Lamp location—Type A and C
Fig. 19 Lamp location—Type B
MESSAGE CENTER REMOVAL
(1) Using a trim stick, remove message module
from instrument panel (Fig. 20).
Fig. 20 Message Center Module
(2) Disconnect connector.
(3) Replace lamps as needed.
(4) For installation, reverse above procedures.