Chrysler Concorde 1993 Service Manual page 222

8A - 2 BATTERY/STARTING/CHARGING SYSTEMS DIAGNOSTICS
memory if the failure does not reoccur during that pe-
riod. This also will translate a monitored failure in the
form of a FAULT CODE when a readout command is
given. A readout command can be made by turning the
ignition switch to ON-OFF-ON-OFF-ON without start-
ing the engine. The CHECK ENGINE LAMP on the in-
strument cluster will flash in predetermined sequences
to show Fault Codes. However, the Check Engine Lamp
cannot express fault codes for all failures. Fault codes
are easier to obtain and more complete with the use of
Diagnostic Tool (DRB II). This tool is plugged into the
diagnostic connector located in the engine compartment
(Fig. 2). Refer to the instructions provided with the
(DRB II) tool being used.
For numbered Fault Codes pertaining to components
within this particular Group, refer to Failure
Codes—On Board Diagnostics in Group 8A. For other
numbered Fault Codes not pertaining to this Group
(8A), refer to On Board Diagnostics in the General Di-
agnosis section of Group 14, Fuel System for more in-
formation.
Fig. 2 Charging System Components