(2) Disconnect electrical connector from solenoid.
(3) Slide transducer up and out of mounting
bracket.
(4) Loosen, but do not remove, the EGR tube to in-
take manifold screws (Fig. 14).
Fig. 14 EGR Tube Upper Mounting Screws
The EGR valve attaches to the rear of the right
cylinder head (Fig. 15).
(5) Remove EGR tube lower screws at EGR valve
(Fig. 15).
(6) Remove EGR valve mounting screws.
(7) Remove EGR valve and transducer.
(8) Clean gasket surfaces. Discard old gasket. If
necessary, clean EGR passages.
Fig. 15 EGR Valve—3.5L Engine
INSTALLATION—3.5L ENGINE
(1) Install EGR valve and new gasket on cylinder
head. Tighten mounting screws to 22 N¼m (200 in.
lbs.) torque.
(2) Using a new gasket, attach EGR tube to EGR
valve. Tighten mounting screws to 11 N¼m (95 in.
lbs.) torque.
EMISSION CONTROL SYSTEMS
(3) Tighten EGR tube to intake manifold plenum
screws to 22 N¼m (200 in. lbs.) torque.
(4) Connect EET solenoid to vacuum fitting on
manifold.
(5) Slide transducer into bracket.
(6) Attach electrical connector to solenoid.
EGR TUBE—3.3L ENGINE
The EGR tube attaches to the intake manifold ple-
num below the throttle body and the right exhaust
manifold (Fig. 16).
Fig. 16 EGR Tube—3.3L Engine
REMOVAL
(1) Remove EGR tube mounting screws at intake
manifold plenum (Fig. 17).
Fig. 17 EGR Tube Upper Mounting Screws
(2) Remove EGR tube mounting screws at exhaust
manifold.
(3) Remove EGR tube. Clean gasket surfaces on
the intake manifold plenum and exhaust manifold.
INSTALLATION—3.3L ENGINE
(1) Using new gaskets, loosely install the EGR
tube and mounting screws.
25 - 15