Chrysler Concorde 1993 Service Manual page 750

(3) Pull parcel shelf trim away from rear glass to
disengage clips.
(4) Disengage seat belt bezels from shelf trim
panel.
(5) Pull rear shoulder harnesses through access
holes in shelf trim.
(6) Separate parcel shelf trim from vehicle.
INSTALLATION
(1) Place parcel shelf trim in position in vehicle.
(2) Insert rear shoulder harnesses through access
holes in shelf trim.
(3) Engage seat belt bezels into shelf trim panel.
(4) Push parcel shelf trim rearward toward rear
glass and engage clips.
(5) Engage CHMSL wire connector.
(6) Install lower quarter trim panels.
Fig. 63 Parcel Shelf Trim Panel
REAR SEAT CUSHION
REMOVAL (FIG. 64)
(1) Pull upward at each end of the rear seat cush-
ion to disengage retainer loops from cups in floor.
(2) Separate rear seat cushion from vehicle.
INSTALLATION
(1) Place rear seat cushion in position in vehicle.
(2) Engage retainer loops into cup on floor kick-up.
(3) Push downward at each end of the rear seat
cushion to engage retainers.
REAR SEAT BACK
REMOVAL (FIG. 65)
(1) Remove rear seat cushion.
(2) Remove nuts holding rear seat back and belts
to floor.
(3) Push rear seat back upward to disengage hooks
at top of seat back.
(4) Separate rear seat from vehicle.
Fig. 64 Rear Seat Cushion
INSTALLATION
(1) Place rear seat in position in vehicle.
(2) Engage hooks at top of seat back.
(3) Install nuts to hold rear seat back and belts to
floor.
(4) Install rear seat cushion.
Fig. 65 Rear Seat Back
FRONT SEAT
REMOVAL (FIG. 66)
(1) Position seat far enough forward to gain access
to rear mount bolts on floor.
(2) Disengage front seat wire harness connector
from body harness connector.
(3) Remove bolts holding front of the seat track to
floor kick-up.
(4) Remove bolts holding rear of seat track to floor.
(5) Separate front seat from vehicle.
INSTALLATION
(1) Place front seat in position in vehicle.
(2) Install bolts to hold rear of seat track to floor.
BODY 23 - 29