Body Electric
Front Wiper Motor Harness Connector CA14
Wiper Switch Harness Connector IP19
Next
Step 6
System normal.
11.6.7.6 Wiper Inoperative At Intermittent
Schematic:
Refer to
11.6.7.3 Wiper Inoperative At All
Diagnostic Steps:
Step 1
Measure the wiper motor harness connector terminal No.1 voltage.
Front Wiper Motor Harness Connector CA14
1
FE11-5507b
Speed.
2 3
4 5
FE11-5503b
Wipers / Washers System
(a)
Check the circuit between the wiper switch wiring harness
connector terminal No.7 and the wiper motor wiring harness
connector terminal No.1.
(b)
Repair the open circuit between the wiper switch wiring
harness connector terminal No.7 and the wiper motor wiring
harness connector terminal No.1.
Confirm the repair completed.
(a)
Turn on the ignition switch.
(b)
Turn the wiper switch to "INT" (intermittent) position, measure
the wiper motor harness connector terminal No.1 voltage with
a multimeter.
Standard Voltage: 11-14 V
Is the voltage specified value?
Go to step 3
No
EC718/EC718RV EC715/EC715RV 10/2009
11-233