Sunroof Can Not Open - Geely EC718 2009 Workshop Manual

Body Electric
No
Repair the open circuits between the sunroof assembly connector RF08 terminals and fuses IF-3, IF-25,
Step 12
IP-8.
No
Replace the sunroof motor assembly.
Step 13
Next
System normal.
Step 14

11.8.7.5 Sunroof Can Not Open

Schematic:
Refer to 11.8.7.4 Sunroof Inoperative.
Diagnostic Steps:
Send a ground signal to the sunroof module.
Step 1
No
Step 2 Check resistance between the sunroof switch and the sunroof module.
(a) Disconnect the roof assembly connector RF08.
(b) Measure resistance between the sunroof assembly
connector RF08 terminals No.1,3,6, fuse IF-3.IF-25.IP-24
respectively, with a multimeter.
Resistance Standard Value: Less than 1 Ω
Is the resistance specified value?
Go to step 13
Yes
(a) Confirm the open circuits between the sunroof assembly
connector RF08 terminals and fuses IF-3, IF-25, IP-8 repair
is completed.
Is the sunroof working properly?
System normal
Yes
(a) Replace the sunroof motor assembly. Refer to
11.8.8.2 Sunroof Motor
Confirm the repair completed.
(a) Remove the sunroof switch. Refer to
Assembly Replacement.
(b) Connect the roof antenna switch harness connector RF06
terminal No.3 and body ground with a suitable antenna.
Is the sunroof motor working properly?
Go to step 5
Yes
(a) Disconnect the sunroof module harness connector.
EC718/EC718RV EC715/EC715RV 10/2009
Sunroof
Replacement.
11.8.8.3 Sunroof Switch
11-311