Turn Signal Lamp Replacement - Geely EC718 2009 Workshop Manual

Body Electric
1
3
2
FE11-0296b
Lighting System
Installation Procedure:
1. Rotate the brake lamp switch locking nut to the top
position.
2. Press the brake pedal to the end.
3. Install the brake lamp switch into the mounting hole (2).
Note
Do not fully tighten the screw.
4. Slowly release the brake pedal until the brake lamp switch
contacts fully pressed in because of brake pedal reaction.
5. Tighten the locking nut (3).
Torque: 10 Nm (Metric) 7 lb-ft (US English)
6. Connect the brake lamp switch harness connector (1).
7. Connect the battery negative cable.

11.4.8.18 Turn Signal Lamp Replacement

Removal Procedure
Warning!
Refer to "Battery Disconnect Warning" in "Warnings and
Notices".
1. Disconnect the battery negative cable. Refer to
2.11.8.1 Battery Disconnection.
2. Remove the outside rearview mirror glass. Refer to
11.5.8.1 Outside Rearview Mirror
3. Disconnect the turn signal lamp wiring harness connector
(1).
4. Remove the retaining screw (2).
EC718/EC718RV EC715/EC715RV 10/2009
11-149
Replacement.