Body Electric
Front Wiper Motor Harness Connector CA14
Wiper Switch Harness Connector IP19
Next
Step 6
System normal.
11.6.7.5 Wiper Inoperative At Low Speed
Schematic:
Refer to
11.6.7.3 Wiper Inoperative At All
Diagnostic Steps:
Step 1
Measure the wiper motor harness connector terminal No.1 voltage.
Front Wiper Motor Harness Connector CA14
(a)
(b)
Confirm the repair completed.
FE11-5510b
Speed.
(a)
(b)
(c)
Is the voltage specified value?
FE11-5503b
Wipers / Washers System
Check the circuit between the wiper switch wiring harness
connector terminal No.8 and the wiper motor wiring harness
connector terminal No.4.
Repair the open circuit between the wiper switch wiring
harness connector terminal No.8 and the wiper motor wiring
harness connector terminal No.4.
Turn on the ignition switch.
Turn the wiper switch to "LOW" (low speed) position.
Measure the wiper motor harness connector terminal No.1
voltage with a multimeter.
Standard Voltage: 11-14 V
Go to step 3
No
EC718/EC718RV EC715/EC715RV 10/2009
11-231