Dtc U150F; Dtc U1400 U1410 U1420 U1430 U1501 U1601 - Geely EC718 2009 Workshop Manual

Body Electric
No
Diagnostic completed.
Step 7

11.7.6.8 DTC U150F

DTC
Diagnostic Steps:
Step 1 Check whether the meter power supply circuit and ground circuit are normal.
No
Replace the instrument cluster. Refer to
Step 2
Next
Use scan tool to confirm whether the DTC Code is stored again.
Step 3
No
Diagnostic completed.
Step 4

11.7.6.9 DTC U1400 U1410 U1420 U1430 U1501 U1601

DTC
DTC
DTC
DTC
DTC
DTC
Diagnostic Steps:
Refer to "Data Communications System" in
U150F EEPROM Checksum Error
U1400 ABS Message Time Out, ABS Communication Lost
U1410 airbag control module Message Time Out, airbag control module Communication Lost
U1420 BCM Message Time Out, BCM Communication Lost
U1430 EMS Message Time Out, EMS Communication Lost
U1501 CAN Network System Integrity Test Failure
U1601 CAN Bus Off
the11.17.7 Diagnostic Information and
Instrument / Driver Information System
Refer to 11.7.6.7 DTC U129C
Yes
11.7.7.1 Instrument Cluster
(a) Connect scan tool to the datalink connector.
(b) Turn the ignition switch to "ON" position.
(c) Clear DTC codes.
(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Read the control system DTC Code again.
DTC codes still exist?
Yes
EC718/EC718RV EC715/EC715RV 10/2009
U129D.
Fault site
Replacement.
Go to step 1
Procedures.
11-297