Wiring Of Ethernet Cable - Mitsubishi Electric MELSEC iQ-R Series User Manual

Wiring of Ethernet cable

Connecting the Ethernet cable
■Connecting
*1 The time taken for the LINK LED to turn on after connection of the cable may vary. The LINK LED normally turns on in a few second.
However, if link-up processing is repeated due to a condition of a device on the line, the longer time may be required. If the LINK LED
does not turn on, refer to the following and take a corrective action.
Page 82 When the LINK LED turns off
1.
Power off the module power supply of the
safety remote I/O module and the power supply
of the external device.
2.
Push the Ethernet cable connector into the
safety remote I/O module, paying attention to
the connector's direction.
3.
Tighten the screw of the Ethernet cable.
4.
Power on the module power supply.
5.
Power on the power supply of the external
device.
6.
Check that the LINK LED on the port into which
the Ethernet cable is connected is on.
6 INSTALLATION AND WIRING
6
*1
41
6.4 Wiring