Module Parameter Setting Procedure - Mitsubishi Electric MELSEC iQ-R Series User Manual

Module parameter setting procedure

The following shows the procedure to set module parameters of the master station from the "Network Configuration Settings"
window.
• When the user authentication function of the Safety CPU is enabled, perform the logon of the user
authentication function in advance. For the user authentication function, refer to the following.
Page 60 User Authentication Function
• Connect the module power supply and the load power supply to set parameters. If the power supplies are
not connected, parameters cannot be written.
1.
For preparation before setting module parameters, follow the steps below.
• Connect the safety remote I/O module to a network and power on the module.
• Connect the engineering tool to the Safety CPU of the master station.
• Build the module configuration in the engineering tool. For details on the setting, refer to the following.
 GX Works3 Operating Manual
• Set the Safety CPU to the TEST MODE. For details on the setting, refer to the following.
 GX Works3 Operating Manual
2.
Display the "CC IE Field Configuration" window.
[Navigation window]  [Parameter]  [Module Information]  Target module  [Module Parameter]  [Basic Settings]
 [Network Configuration Settings]  "CC IE Field Configuration" window
8 PARAMETER SETTINGS
8.1 Module Parameter Setting of the Master Station
8
65