8.2
Module Parameter Setting
Module parameter setting procedure
The following shows the procedure to set module parameters of the safety remote I/O module from the "Network
Configuration Settings" window.
When the user authentication function of the Safety CPU is enabled, perform the logon of the user
authentication function in advance. For the user authentication function, refer to the following.
Page 60 User Authentication Function
1.
Display the "CC IE Field Configuration" window.
[Navigation window] [Parameter] [Module Information] Target module [Module Parameter] [Basic Settings]
[Network Configuration Settings] "CC IE Field Configuration" window
2.
Display the "Parameter Processing of Slave Station" window.
Select the target safety remote I/O module. [CC IE Field Configuration] [Online] [Parameter Processing of Slave
Station]
8 PARAMETER SETTINGS
8.2 Module Parameter Setting
8
67