Mitsubishi Electric MELSEC iQ-R Series User Manual page 38

Cc-link ie field network waterproof/dustproof remote i/o module (with safety functions)
Hide thumbs Also See for MELSEC iQ-R Series:
Table of Contents

Advertisement

Ex.
To set the station to 115, set the switch as shown below.
Setting range
Set the station number from 1 to 120. Setting the value other than 1 to 120 causes a communication error and the D LINK
LED flashes.
• Do not change the station number setting switch while the module power supply is on. Changing the station
number setting switch causes a minor error and the ERR. LED flashes. Returning the station number setting
switch to the previous setting eliminates the error five seconds later and the ERR. LED turns off.
• Do not set a same station number as another station number. If a duplicate station number is used, a
communication error occurs and the D LINK LED does not turn on.
Tightening torque
Tighten the screw for the station number setting switch cover within the following tightening torque range.
Screw type
Station number setting switch cover (M3 screw)
• Do not put oil on the screw. Failure to do so may damage the screw.
• Tighten the screw with an applicable screwdriver. Tightening it with an inapplicable screwdriver may
damage the screw.
6 INSTALLATION AND WIRING
36
6.1 Setting the Station Number
Tightening torque range
0.43 to 0.57Nm

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nz2gfs12a2-14dtNz2gfs12a2-16dte

Table of Contents