Adtech CNC9 Series Maintenance Manual page 5

Foreword
CNC9 series CNC system is an economic embedded CNC system developed by Adtech (Shenzhen) Technology
Co., Ltd. for lathe and milling machines and machining centers, where CNC9640 is four axes motion controller,
CNC9960 is six axes motion controller, CNC9650 and CNC9810 are five axes motion controllers, and
CNC9810E is bus motion controller. (Note: ETherCAT bus control can be configured at most 12 axes of thread.)
Instructions and reading convention of the Manual
Before using this CNC system, please read this Manual carefully to operate properly.
Terminology note and reading convention in this Manual:
CNC9640 is control systems with different axes and same hardware functions. The programs developed on this
platform contain M series software for milling machines and L series software for lathes. Different software has
different functions and masks.
M series are system for milling machine motion. The 'M' or "M series" mark indicates specific interface or
function for milling machine software system.
L series are system for lathe motion. The 'L' or "L series" mark indicates specific interface or function for lathe
software system.
"CNC system", "NC controller" and "CNC9XXX" mentioned in this Manual all refer to
CNC9640/CNC9960/CNC9810/CNC9816;
The articles marked with "Caution" prompt users to pay special attention for operation or setting, or else this
operation may fail or certain action can't be performed.