Adtech CNC9 Series Maintenance Manual page 34

Since the e input point o on the ADT i
be conne ected to 0V in n parallel. The
points on n the input bo oard. If the or
for tool s setting detecti ion.
2. E Enable tool re gulator: Coor
--------- B By setting it t to ON, you ca
set to OF FF, the tool re egulator canno
input board su upplies +24V
e orange and green lines a
range and blac ck lines are re
rdinates -> C oordinates pa
an enable the tool regulato
ot be enabled d. .
- 29 -
ADTE ECH9 Series C
V, the black an nd yellow line
are respective ly connected
eversed at tim me of connect
arameter -> 2 29. Whether to
or and perform m the tool set
CNC Maintenan nce Manual
es in the abov ve figure mus
to the corres sponding inpu
tion, there wi ill be no inpu
o enable the t tool regulator
tting operatio on. When it is
st
ut
ut
r