Adtech CNC9 Series Maintenance Manual page 168

Range
Unit
Authority
Default
Effective time
Note
020 Sys debug information enable
Range
Unit
Authority
Default
Effective time
Note
021 Axis control composite enable
Range
Unit
Authority
Default
Effective time
Note
: Axis group 1 Axis group 2 GRUN4 GRUN5 GRUN6
: None
: Super user
: XYZ
: Instant
: To set the multi-channel G code configuration that is started in parallel
when the system starts running the machining program
: 0~1
: None
: Super user
: OFF/0
: Instant
: Used to configure whether RS232 of current system outputs the testing info
while program is running.
This parameter is dedicated for programmers, and the users are not
suggested using this parameter.
If the testing info is enabled, the system performance will be lowered, and
therefore it is disabled during normal processing.
If networking is enabled, this function must be disabled, or else the
networking will fail.
: 0~1
: None
: Super user
: ON/1
: Instant
: Used to configure whether the key for axis motion on the control panel is
enabled.
This parameter is used to shield the composite function of the key for axis
motion on the NC panel and reduce the possibility of misoperation when
- 163 -
ADTECH9 Series CNC Maintenance Manual