Adtech CNC9 Series Maintenance Manual page 120

Effective time
Note
014 Circle Inp Unit(mm)
Range
Unit
Authority
Default
Effective time
Note
015 G73(M) Loop Obligate(mm)
016 G83(M) Loop Obligate(mm)
Range
Unit
Authority
Default
Effective time
Note
017 Arc interpolation processing mode
Range
Unit
Authority
Default
Effective time
Note
018 Speed optimization constraint mode
Range
: Restart
: The ID number setting of the controller when DNC or other PC
software and this controller are in MODBUS communication mode
: 0~1
: mm
: Operation admin or higher
: 0.2
: Instant
: Set the arc interpolation equivalent
If this value is too small, the arc has higher approximation accuracy, but
the computation will be too high, making the pause during processing
obvious and affecting the processing effect.
: 0.1~100
: mm
: Operation admin or higher
: 2.000
: Instant
: Set the tool retracting amount after Q is fed in G73 and G83
instructions; this parameter (default: 2mm) is set according to actual
chip removal effect.
: Time split, position split
: None
: Operation admin or higher
: Position split
: Instant
: Position split is done based on arc length
Time split is done by time.
: Angle Speed Speed1
- 115 -
ADTECH9 Series CNC Maintenance Manual