Adtech CNC9 Series Maintenance Manual page 169

022 Additional panel enable
Range
Unit
Authority
Default
Effective time
Note
023 M code macro program selection
Range
Unit
Authority
Default
Effective time
Note
024 T macro program selection
Range
Unit
Authority
Default
Effective time
additional panel is used. However, if no additional panel is used, this
parameter must be enabled, or else the axis motion can't be controlled
through the key.
: OFF FCNC4M FDK4A FCNC900V FCNC6D
: None
: Super user
: OFF/0
: Instant
: Used to configure whether NC uses additional panel, which must be ADT
matching additional panel, or compatible with the interface of same
protocol.
If additional panel is used, the system testing info enable must be
deactivated (P3.20).
: MFUNC User-Def
: None
: Super user
: MFUNC
: Restart
: Used to configure M code macro program of the system, MFUNC uses the
default M code macro program, and User-Def uses user-defined
M_FUNC.NC.
: TFUNC User-Def
: None
: Super user
: TFUNC
: Instant
- 164 -
ADTECH9 Series CNC Maintenance Manual