Adtech CNC9 Series Maintenance Manual page 32

If there is no question, press [EOB] again to return the result to specified coordinate system.
⑵ Square centered
Select the edit mode;
Press [Coordinates], [Coordinates Parameter] to enter the auxiliary parameters setting interface of the
coordinate system;
Move the cursor to desired position, enter new parameters and press [EOB];
Select handwheel or manual mode;
Press [Coordinates] to enter coordinate system setting interface;
Press the left/right arrow to move the cursor to select coordinate system;
Press [Centered Measurement] to enter centered interface;
Move the tool to make its side blade touch side A surface of the workpiece, and press [EOB] to record
boundary point 1;
Move the tool to make its side blade touch side B surface of the workpiece, and press [EOB] to record
boundary point 2;
Record boundary point 3.4 in the same method;
Press [EOB] after recording all boundary points to calculate the coordinates of center point;
If there is no question, press [EOB] again to return the result to specified coordinate system.
⑶ Plane circle (XY plane) centered
Circle centered has two modes, which are three points and two points with specified radius; If the user only
types two coordinates in the option of workpiece boundary point and specifies one value for R, the system will
determine the circle center with two points and radius automatically; if the user types coordinates of three points
in the option of workpiece boundary point, the system will determine the circle center with three points and
shield R.
The centered steps of three points arc are as follows:
Select the edit mode;
Press [Coordinates], [Coordinates Parameter] to enter the auxiliary parameters setting interface of the
coordinate system;
Move the cursor to desired position, enter new parameters and press [EOB];
Select handwheel or manual mode;
Press [Coordinates] to enter coordinate system setting interface;
Press the left/right arrow to move the cursor to select coordinate system;
ADTECH9 Series CNC Maintenance Manual
- 27 -