Ccu Connection; Connecting Camera And Ccu - Ikegami HDK-790GX Operation Manual

3.5 CCU Connection

This section explains how to connect the HDK-790GX to the CCU. CCU-970 is used here as an example.
Two types of ber cables are available in different shapes.
- Fiber cable (2-core single mode) : Diameter 9.2mm or 16mm, Maximum length 2000m (when CCU-970 is used)

Connecting Camera and CCU

OPT
CAMERA connector
1
Connect the CAMERA connector on the rear of the CCU-970 to the CAMERA connector on the front of the
camera via a fi ber cable.
Caution:
- The ber cable has a male plug connector on one end and a female plug connector on the other end. Be sure to connect the
female plug connector to the camera and the male plug connector to the CCU.
- Secure the ber cable with the CAMERA CABLE clamp on the front side of the camera to remove any slack. See "SAFETY
PRECAUTIONS" described at the beginning of this manual for how to secure the cable with the cable clamp and how to
handle the ber cable.
3G/SDI OUT
Fiber cable
HDK-790GX 1403 VER1 (U)
Camera front view
CCU-970 rear view
3.5 CCU Connection
CAMERA connector
45
3