Auto Black Balance; Auto Black Shading - Ikegami HDK-790GX Operation Manual

Auto Black Balance

Perform the auto black balance from OCP or MCP. You cannot perform from the camera.
1
Press the "ABB" button on the OCP or MCP.
The status is automatically changed to the CAP status and then the auto black
balance will be performed.
2
Check the results.
When the auto black balance is completed, "OK" or "NG" will be displayed on the
view nder screen.
Caution:
Be sure to set the R/G/B FLARE and MASTER PEDESTAL control knobs on the
OCP to the center position before activating the auto black balance from the camera.
If the control knobs are not at the center position, the control range will be biased to
one side.

Auto Black Shading

Perform the auto black shading from OCP or MCP. You cannot perform from the camera.
This section explains how to perform it from OCP-200.
1
Press the "SET UP" button on the OCP-200.
The "CAMERA SETUP" menu will be displayed in the LCD panel.
2
Press the "AUTO SETUP" button.
The "AUTO SETUP" menu will be displayed in the LCD panel.
3
After pressing the "ABS" button, press the "Start" button.
The auto black shading will be performed.
4
Check the results.
When the auto black shading is completed, "OK" or "NG" will be displayed on the
view nder screen.
Note:
- When the result of the auto black balance is "NG", the auto black shading will be
stopped.
- When you want to stop the auto black shading, press the "Start" switch again
before the result is displayed. The setting that has been corrected up to that point
will be cleared, and returns to the state it was before performing the auto black
shading.
HDK-790GX 1403 VER1 (U)
4.6 Auto Setup
ＡＢＢ
ＢＫＬ ＳＥＴ
ＡＢＢ
Ｏ Ｋ
LCD panel
CAMERA SETUP
GRAY
DETAIL COLOR
SCALE
AUTO
DOWN CONV. DOWN CONV.
DETAIL COLOR
SETUP
MODE
CHARACTER
SWITCH
AUTO SETUP
Test
Full Level Quick
Pulse
Skin
ABS Color Diascope
Hue
Start
Viewfinder screen
A. BLACK SHADE
BLK SET
A. BLK SHADE
BLACK SHADE
A. BLK SET
O K
4
61