Ikegami HDK-790GX Operation Manual page 33

ECC (Electric Color Conversion) FILTER switch
A switch used to select the ECC lter from the camera side.
A : 3200K
B : 4300K
C : 5600K
D : 6300K
E : 8000K
EFFECT (Effect) FILTER switch
A switch used to select the EFFECT lter from the camera side.
Ⅰ : CLEAR
Ⅱ : CROSS
Ⅲ : SNOW CROSS
Ⅳ : FOGGY
Ⅴ : CLEAR
FILTER HEAD switch
A switch used to switch the settings for each lter from the
camera side. If an operation is enabled on the camera side
during the CCU operation, the "*" mark and the selected
lters will be displayed on the left bottom corner of the
view nder screen.
FILTER local indicator
Lights up when the lter operation is enabled on the camera
side.
⑦ PANEL LAMP button
A button used to turn off the lamp for the panel when the rear cover is closed.
The lamp is turned off when the panel lamp switch is "ON" (when the panel lamp is lit), and then the rear cover is closed.
⑧ PANEL LAMP switch
A switch used to turn ON/OFF the lamp of camera control panel.
⑨ VF MARKER switch
Displays the safety marker (16:9/4:3), safety area (action, title area), center marker, frame marker (16:9/4:3) on the view nder
screen.
⑩ CHARACTER switch
Displays various information with characters on the view nder.
MENU : Displays the information for when it is "ON" as well as the special items such as camera work time, and sets various
menu settings.
ON : Displays the lter position and shutter speed (when the shutter function is turned ON).
OFF : Does not display information.
The information will be displayed when performing the AUTO SETUP, and the warning will be also displayed even if the switch is
set to "OFF".
⑪ MENU SELECT switch
A switch used to select the menu and con rm the setting value when it is in the MENU mode with the CHARACTER switch.
⑫ VF IND control knob
A knob used to change the brightness of cursor and markers to be displayed on the view nder screen.
Turn it left to make it darker, and turn it right to make it brighter.
⑬ VD DTL control knob
A knob used to control the edge level of DTL correction for the view nder image.
⑭ FAN indicator and switch
Cooling fans are equipped at the bottom of camera and in the HEAD POWER BOX module to prevent the temperature from
increasing inside the camera. This switch is used to control these cooling fans.
AUTO : Automatically controls the speed of fan (high or low speed) according to the inside temperature.
SLOW : Turns on the fan at the low speed. If a sense of serenity is required upon the operation, press down the switch for 2
seconds. The indicator lights up, and then it returns to the AUTO mode after 5 minutes.
Viewfinder screen
２ Ｂ Ⅱ *
Displays the selected ECC filter.
Displays the selected ND filter.
HDK-790GX 1403 VER1 (U)
2.1 Camera and Viewfi nder
Displays " *" when the camera has
operational priority.
Displays the selected EFFECT filter.
2
17