Connecting The Headset - Ikegami HDK-790GX Operation Manual

Connecting the Headset

This product can connect an intercom to the two lines (INCOM-1 and INCOM-2). Select the line according to the use (for engineer
or for producer, etc). This section explains the use case for INCOM-1.
1
Connect a headset connector to the INCOM-1
connector.
2
Turn on the INCOM-1 switch.
Caution:
Do not set the volume of intercom receiver to near
maximum level from the beginning. Using the
intercom with loud volume may cause a ruptured or
damaged eardrum.
Reference:
Adjust the volume when the sound from the intercom
receiver is dif cult to hear or too loud. See "5. Camera
settings and adjustments [Audio volume adjustment
of headsets]" for the audio volume adjustment of
intercom.
3.2 Camera and Peripheral Installation and Connection
Camera rear view
CAMERA
ＯＮ
ＳＴＢＹ
INCOM-1
① Plug the
headset
connector
HDK-790GX 1403 VER1 (U)
FOCUS
EXT ASSIST FUNC
RET-2 RET-3
RET-1
2 3 2 3 2 3
1 4 1 4 1 4
CALL
INCOM-2
INCOM MIC SEL INCOM MIC SEL
MIC MIC
ON PROD ON PROD
OFF BOTH OFF BOTH
PTT ENG PTT ENG
PGM-1 PGM-2 PGM-1 PGM-2
CAUTION : Ensure that the volume
is initially set at a
minimum level.
② Turn ON
INCOM connector
3
41