Table of Contents
Advertisement
5.2 Settings from the Menu
- - -
FILE SET
FILE SET creates a lens le.
To change the settings, select "LENS SELECT" on MENU (3/4), then "FILE SET".
The following explains the set values, descriptions, and setting procedures.
Set Value
OFF (default)
MANUAL
AUTO
Chart on which Kent paper, etc. has been pasted
and the entire surface is a uniform white.
Illumination
meter
Light
Note:
- The creation of lens le requires precise adjustment; therefore, lens les are protected against unintentional update by the S11-4 DIP
switch of the MPU module.
- When creating a lens le, set the optical lter to ND:100% and the ECC lter to 3200K. Also con rm that no special effect lter is
attached to the front of the lens or internal lter disk. If a special effect lter is attached, it may not be possible to correctly create the
lens le.
- When operating the DIP switch (S11) in the MPU module, turn the POWER switch of the camera OFF once.
1
Set the camera for level setup.
- Mount the standard lens, which is used as a reference lens, to the camera.
- Chart on which Kent paper, etc. has been pasted and the entire surface is uniform white is used for the photographic
subject.
- Use an illumination meter to adjust the light so that light is evenly distributed over the whole chart.
2
Dip switch S11-4 On allows creation of a lens fi le, Off prohibits creation of new lens fi les.
76
Does not create lens files.
Stores the current lens status as a file. ("LENS No. x" will be displayed at the bottom of the screen.)
Starts auto setup for lens file creation. ("PUSH SET -> START" will be displayed and flash at the bottom of the screen.)
Light
Picture monitor
(connect if required)
HDK-790GX 1403 VER1 (U)
Description
Camera
MON SDI OUT connector
Tripod
WFM
Coax cable
Advertisement
Table of Contents
