Ikegami HDK-790GX Operation Manual page 35

⑥ Q-TV/GL IN and MON OUT connector
A connector used to output the selected signals using the Q-TV/GL IN and MON OUT selector switch.
- When it is set to "Q-TV/GL"
Changes the analog video signal that is input into the Q-TV connector on the back of CCU to the Q-TV signal (video trunk
input) for the monitor to output. The Q-TV signal output function is supported only during the CCU operation.
It inputs the PS/S signal (tri-level sync signal) as an external sync signal (genlock input). The external sync signal input is
supported only during the self-contained operation.
- When it is set to "MON OUT"
Outputs the monitor signal. Select the MON and SYNC signals from the camera menu.
⑦ MONI-SDI OUT connector
A connector used to output the HD SDI signal.
Select the VF, MAIN, RETURN, and HD Q-TV signals from the camera menu.
⑧ QTV-2 connector
A connector used to output the QTV-2 signal.
⑨ HD TRUNK IN connector
A connector used to input the HD TRUNK signal (1.5G-SDI).
The input 1.5G-SDI signal can be output from the connector on the back of CCU.
Caution:
The HD TRUNK output for the CCU-970 is optional.
⑩ REMOTE connector
A connector used to connect the various remote control panels (OCP, MCP, RCP) and communicate the various control signals
during the self-contained operation.
⑪ I/O connector
A multi-connector that includes the GREEN/RED TALLY control output signal, RET-1 and RET-2 control input signals, and RS-
422 data control signal, etc.
⑫ MIC POWER switch (option)
A switch to change the power supply for the microphone that is connected to the MIC-1and MIC-2 connectors.
Select it depending on the type of microphone to be used.
AB+12V : Supplies power to the microphone for +12V AB power.
OFF : Does not supply power to the microphone. If the dynamic microphone or microphone includes a built-in power supply
and does not require power supply, use it in this position.
+48V : Supplies +48 V phantom power to the microphone.
HDK-790GX 1403 VER1 (U)
2.1 Camera and Viewfi nder
19
2