Ikegami HDK-790GX Operation Manual page 58

3.5 CCU Connection
- - -
Removing the Fiber Cable
This section explains how to remove the ber cable.
Caution:
When you remove the cable, be sure to hold the plug and pull. Failure to do so may damage the ber in the cable.
Camera
OPT
3G/SDI OUT
CCU
1
Remove the cable from the camera while pulling the unlocking ring on the fi ber cable plug (female) toward you.
If the connector tip is locked, the ber cable will not be removed. If it is locked, push the ber cable toward the CAMERA
connector, and then remove as described above.
2
Remove the cable from the CCU-970 while pushing the unlocking ring of the CAMERA connector on the rear of
CCU-970.
If the connector tip is locked, the ber cable will not be removed. If it is locked, push the ber cable toward the CAMERA
connector, and then remove as described above.
46
Camera front view
CAMERA connector
(male)
CCU-970 rear view
CAMERA connector (female)
Unlocking ring
HDK-790GX 1403 VER1 (U)
Unlocking ring
Plug (female)
Fiber cable
Plug (male)
Fiber cable