Fitting And Connecting The Mounting Plate Of The Mmx-Net-Xa; Cover Of The Mmx-Net-Xa For Holding The Fieldbus Interface Card; Connecting The Interface Card With The Frequency Inverter - Eaton M-Max Series User Manual

Appendix A
The remaining installation steps are then carried out without any tools
using the cutouts provided in the housing of the MMX (snap fixing).
Fit the plug and connection cable onto the interface of the MMX
●

Fitting and Connecting the Mounting Plate of the MMX-NET-XA

You can then fit a fieldbus interface card (for example,
PROFIBUS DP, and so on) in the cover of the mounting
frame.
Note: Before installing the fieldbus interface card check
whether the plug connection provided, such as GND
or bus terminal resistor have to be changed.
Cover of the MMX-NET-XA for Holding the Fieldbus
Interface Card
Then fit the cover with the inserted fieldbus interface card
●
onto the already fitted and installed mounting plate of the
MMX-NET-XA
154 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com
W /T 3
Connecting the Interface Card with the Frequency
Inverter
Make the connections to the selected fieldbus system
●
through the opening in the mounting frame directly on the
card