Page 1
Matrix 2000 Inverter Installation and Operation Guide Issue: IPN 997-00012-72C Issue Date: July 2017 Eaton Corporation Telecommunications Power Solutions www.eaton.com/telecompower DCinfo@eaton.com...
Page 2
The information contained in this literature is subject to change without notice. Subject to the right to use its equipment, Eaton Corporation does not convey any right, title or interest in its intellectual property, including, without limitation, its patents, copyrights and know-how.
Purpose The purpose of this manual is to provide explanations and procedures for installing, operating, maintaining, and troubleshooting a Matrix 2000 Inverter. This manual should be read through carefully before installation and operation. Please retain this manual for future reference.
Alarm and monitoring is provided by an LCD screen, alarm LEDs and an alarm relay output. Part Numbers Part Number Description INV-4820ESA Matrix 2000, 2000VA/2000W standalone inverter module with automatic transfer switch, 230V ac nominal output. 2 x IEC 320-C13 output sockets. INV-4820SA Matrix 2000, 2000VA/2000W standalone inverter module with automatic transfer switch, 120V ac nominal output.
Battery Precautions Inspecting the Equipment and Reporting Damage General Only mount the Matrix 2000 Inverter in either an open-frame relay rack or an enclosed cabinet. The Matrix 2000 Inverter is not designed for "bench top" or any other mounting arrangement.
If the Matrix 2000 is installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Safe: Do not install in a battery compartment or other areas where flammable fumes may ...
Connect ac cords from the ac output plugs to the load equipment. DC Connections The maximum dc input current is 46.3A. The cables from the dc supply to the Matrix 2000 must be in accordance with local electrical codes or regulations.
Set the remote control switch or relay contacts to be OPEN. If off, turn on the Matrix 2000 using the front panel ON/OFF power switch. Close the remote control switch or relay contacts to turn off the Matrix 2000 (after a 0.5s delay).
Eaton. This includes disassembly and/or servicing of any modules. For further information on Servicing contact your local Eaton dc product supplier, or refer to the contact details on page 29. Topic Page...
Matrix Standalone Inverter Troubleshooting If the Matrix 2000 fails to operate properly after installation and setup, use the following tables to determine the probable cause(s) and solution(s) to resolve the error conditions. For unlisted error conditions, please contact your local dealer for technical assistance. See Worldwide Support on page 29.
Page 33
Please enter as much information as you can. Send the completed form, together with the item for repair to your nearest authorized service agent. NOTE: Only one fault to be recorded per form. For further information contact your local Eaton dc product supplier or Eaton (see contact details on page 29). Or email: CustomerServiceNZ@eaton.com...
Page 35
Worldwide Support For product information and a complete listing of worldwide sales offices, visit Eaton's website at: www.eaton.com/telecompower or email: DCinfo@eaton.com For technical support contact either your local Eaton dc product representative, the closest office from the following list, telephone (+64) 3 343-7448, or email CustomerServiceNZ@eaton.com...