Eaton M-Max Series User Manual page 146

Parameters
Setpoint Input (REF), continued
Sequence Commands
3
BACK
RESET
OK
4
FWD
REV
130 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com
Display
READY RUN STOP ALARM FAULT
REF
MON
PAR
FLT
FWD REV I/O KEYPAD
Display in Automatic
READY RUN STOP ALARM FAULT
REF
MON
PAR
FLT
FWD REV I/O KEYPAD
READY RUN STOP ALARM FAULT
REF
MON
PAR
FLT
FWD REV I/O KEYPAD
READY RUN STOP ALARM FAULT
REF
MON
PAR
FLT
FWD REV I/O KEYPAD
Description
If the supply voltage is switched on with the KEYPAD control
level set, the MON menu item is activated first. The set display
value is shown in automatic alternation (factory setting: M.1.1
0.00 Hz)
BUS
BUS
Actuate the BACK/RESET,
level is then reactivated (see sequence 2)
The two arrow buttons (< or >) are used to change the rotating
direction (FWD, REV)
The rotating direction change is carried out in the factory setting
(P6.14 = 0) with an automatic stop at 0 Hz. For a direct changeover
(FWD/REV) you must set parameter P6.14 = 1
Note: The frequency of the REV rotating field direction is not
displayed with a negative sign
Note: When the setpoint entry is active (flashing number display), the
arrow buttons are used to change the entry locations (cursor)
BUS
BUS
and OK buttons in succession. The entry