System Parameters In The Quick Start - Eaton M-Max Series User Manual

Appendix A
Quick Start Parameter Guide, continued (Full parameter guide begins on Page 161)
Access
PNU ID RUN
P7.1 113 X
P7.3 112 X
P7.4 120 X
P7.5 110 X
P7.6 111 X
P11.7 109 X
M1.1 1 X

System Parameters in the Quick Start

Access
PNU ID RUN
S1.1 833 X
S1.2 834 X
S1.3 835 X
S1.4 836 X
S1.5 837 X
S1.6 838 X
S1.6 838 X
S2.1 808 X
S2.2 809
S2.3 810
S2.4 811
Notes
Factory settings dependent on specific drive selected.
These parameters are overwritten with the bus-specific parameters when a fieldbus connection (for example, CANopen) is used.
The parameter values described in the manual of the fieldbus interface then apply.
162 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com
ro/rw Designation
rw Motor, rated operational current
rw Motor, rated speed
rw Motor, power factor
(cos )
rw Motor, rated operating voltage
rw Motor, rated frequency
rw Torque increase
ro Output frequency
ro/rw Designation
ro API SW ID
ro API SW Version
ro Power SW ID
ro Power SW Version
ro Application ID
ro Application revision
ro System load
ro Communication status
rw Fieldbus protocol
rw Slave address
rw Baud rate
Value Range
0.2 x I e –2 x I e
(see motor rating plate)
300–20000 RPM
(see motor rating plate)
0.30–1.00
see
( motor rating plate)
180– 500V
(see motor rating plate)
30–320 Hz
(see motor rating plate)
0 = Deactivated
1 = Enabled
Hz
Value Range
—
—
—
—
—
—
—
RS485 in xx.yyy format
xx = Number of error messages
(0–64)
yyy = Number of correct messages
(0–999)
0 = FB disabled
1 = Modbus
1–255
0 = 300
1 = 600
2 = 1200
3 = 2400
4 = 4800
5 = 9600
FS User
Page (P1.3) Setting
89 I e
89 1720
89 0.85
89
89 60.00
109 0
127 0.00
FS User
Page (P1.3) Setting
125 —
125 —
125 —
125 —
125 —
125 —
125 —
125
125 0
125 1
125 5