Eaton M-Max Series User Manual page 102

Parameters
Drives Control, continued
Access
PNU ID RUN
P6.15 184
P6.16 1474
P6.17 1427 X
P6.18 1428 X
P6.19 502
P6.20 503
P6.21 526 X
P6.22 1334 X
P6.23 1429 X
86 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com
Value/Range Description
— Keypad frequency reference (REF)
–P6.4–P6.4 Hz The setpoint value (REF) defined here can be activated at
parameter P6.2 and via the keypad (LOC/REM)
In KEYPAD mode, the value can be changed with the arrow
buttons. The changes are written back automatically to this
parameter (P6.15)
— Stop button active
In the default settings, the STOP button of the keypad is
active in all operating modes
The Stop function can be set at parameter P6.8
0 No (deactivated)
Stop executed only via control signal terminals (I/O) or
fieldbus (BUS)
Switching the LOC/REM button to KEYPAD removes the
block on the STOP button function set here
Note: This does not deactivate the Reset function (FS
loading with 5s actuation of the STOP button)
1 Yes (activated)
— Secondary remote control source
Assignment of the control levels as at P6.1
Control level 2 is activated via parameter P3.25
— Secondary remote speed reference
Assignment of setpoint sources as at P6.2
Setpoint source 2 is activated via parameter P3.26
— Secondary acceleration time (acc2)
0.1–3000s See Note 1 of parameter P6.5
The activation is executed via parameter P3.15
— Secondary deceleration time (dec2)
0.1–3000s See Note 1 of parameter P6.6
The activation is executed via parameter P3.15
— Acceleration transition frequency (acc1–acc2)
0.00–P6.4 Hz 0.00 Hz = deactivated
If the output frequency set here is exceeded, the
acceleration time is switched automatically from acc1 (P6.5)
to acc2 (P6.19)
— Deceleration transition frequency (dec1–dec2)
0.00–P6.4 Hz 0.00 Hz = deactivated
If the output frequency set here is exceeded, the
deceleration time is switched automatically from dec1 (P6.6)
to dec2 (P6.20)
— REV blocked
The rotating field reversal of the output frequency is blocked
0 Deactivated
1 Activated
Factory Setting
(P1.3)
0.00
1
3
2
10.0
10.0
0.00
0.00
0