Eaton M-Max Series User Manual page 90

Parameters
Digital Inputs, continued
Access
PNU ID RUN
P3.12 1020
P3.13 1400 —
P3.14 1401
P3.15 1402
P3.16 1403
P3.17 1404
P3.18 1405
P3.19 1406
P3.20 1407
P3.21 1408
74 M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com
Value/Range Description
— PID controller deactivate
Like P3.2 Allocation of the function to control signal terminals
When switching on +24V power, the PID controller is
blocked via the assigned control signal terminal (DI1 to DI6)
— (Not used)
— External brake, feedback signal (N/O)
Like P3.2 Assignment of control signal terminal
— Change acceleration/deceleration time (acc 2/dec 2)
Like P3.2 Assignment of control signal terminal
Switch acceleration time from acc1 (P6.5) to acc2 (P6.19)
Switch deceleration time from dec1 (P6.6) to dec2 (P6.20)
— Stop acceleration/deceleration time
Like P3.2 Assignment of control signal terminal
Stops all acceleration (P6.5, P6.19, P14.9) and deceleration
times (P6.6, P6.20, P14.10)
— Block parameter access
Like P3.2 Assignment of control signal terminal
Blocks access to all parameters
Note: The resetting of all parameters to the default settings
via the STOP button (held down 5s) remains active
— Motor potentiometer, increase value
Acceleration time, see "P6.5" (acc1)
Like P3.2 Assignment of control signal terminal
— Motor potentiometer, decrease value
Deceleration time, see "P6.6" (dec1)
Like P3.2 Assignment of control signal terminal
— Motor potentiometer, set value to zero
Like P3.2 Assignment of control signal terminal
— PLC program start
Like P3.2 Assignment of control signal terminal
Factory Setting
(P1.3)
6
—
0
0
0
0
0
0
0
0