Eaton M-Max Series User Manual page 89

Digital Inputs, continued
Access
PNU ID RUN
P3.6 406
P3.7 414
P3.8 407
P3.9 419
P3.10 420
P3.11 421
The binary connection of three digital inputs enable calling seven fixed
frequencies (eight fixed frequencies if parameter P6.2 = 0 is set)
The limitation of the fixed frequencies is done based on parameters
P6.3 (minimum frequency) and P6.4 (maximum frequency)
The switch between the individual fixed frequencies is done with the
acceleration time and deceleration times in P6.5 and P6.6
Function to Control Signal Terminals
Input (Binary)
B0 B1 B2
X
X
X X
X
X X
X X
X X X
Value/Range Description
— Ext. fault open (N/C)
Like P3.2 Allocation of the function to control signal terminals
Error message when switching off or interrupting
(wire-breakage-safe) the applied control voltage (+24V) from
the assigned control signal terminal (DI1 to DI6)
— Fault reset
Like P3.2 Allocation of the function to control signal terminals
Acknowledges a displayed error message (Reset) when
switching on +24V on the assigned control signal terminal
(DI1 to DI6)
— Run enable
Like P3.2 Allocation of the function to control signal terminals
Rotational direction-independent start release when switching
on +24V on the assigned control signal terminal (DI1 to DI6)
— Fixed frequency, binary value B0
Like P3.2 Allocation of the function to control signal terminals
per table below
— Fixed frequency, binary value B1
Like P3.2 Allocation of the function to control signal terminals
per table below
— Fixed frequency, binary value B2
Like P3.2 Allocation of the function to control signal terminals
per table below
Fixed Frequency
(Factory setting)
FF0, P10.1 = 6 Hz, only if P6.2 = 0
FF1, P10.2 = 12 Hz
FF2, P10.3 = 18 Hz
FF3, P10.4 = 24 Hz
FF4, P10.5 = 30 Hz
FF5, P10.6 = 36 Hz
FF6, P10.7 = 48 Hz
FF7, P10.8 = 60 Hz
M-Max Series Adjustable Frequency Drive MN04020003E—October 2013 www.eaton.com
Parameters
Factory Setting
(P1.3)
0
5
0
3
4
0
73