Loosening The Fork Protector; Positioning The Fork Protector; Removing The Fork Legs; Installing Fork Legs - KTM 450 EXC Owner's Manual
Hide thumbs
Also See for 450 EXC:
- Owner's manual (136 pages) ,
- Setup instructions (31 pages) ,
- Owner's manual (70 pages)
Table of Contents
Advertisement
SERVICE WORK ON THE CHASSIS
Loosening the fork protector
10.5
Positioning the fork protector
10.6
Removing the fork legs
x
10.7
Installing fork legs
x
10.8
–
Remove screws
–
Remove screws
–
Remove the screws on the right fork leg. Push the fork protector downwards.
600875-11
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and wiring harness. Put the clamp on, and mount and
tighten screws
–
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
600875-10
–
Remove front wheel.
–
Remove screws
–
Remove cable clip
–
Allow the brake caliper and brake line to hang tension-free to the side.
100802-10
–
Unscrew screws
–
Unscrew screws
100803-10
–
Position the fork legs.
Info
The topmost milled groove in the fork leg must be flush to the upper edge of
the upper triple clamp.
Position bleeder screws
100021-10
and remove the clamp.
on the left fork leg. Push the fork protector downwards.
M6
.
M6
(
p. 70)
x
and remove the clamp.
, remove screw
and remove the brake caliper.
. Take out the left fork leg.
. Take out the right fork leg.
toward the front.
45
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
Advertisement
Table of Contents
