Air Atomizing Spray Process; Round And Flat Jet; Round Jet; Flat Jet - WAGNER GM 2800EA Operating Manual

EDITION 10/2005
OPERATING MANUAL
4.5

AIR ATOMIZING SPRAY PROCESS

4.5.1

ROUND AND FLAT JET

In this process, the material (paint) is fed to the tip with low pressure at approx. 0.05-0.2MPa;
0.5-2 bar; 7-29 psi. The atomizing air at approx. 0.25-0.4 MPa; 2.5-4 bar; 36-58 psi produces a
soft jet, which largely eliminates the problem of overlapping boundaries.
4.5.2

ROUND JET

The jet is cone-shaped.
1 Atomizing air
4.5.3

FLAT JET

The spraying angle can be changed by adjusting the „fan air". Depend on the material and
the output, a large range of tips and air caps are available to suit your needs (see para.
9.1).
1 Atomizing air
PART NO. DOC0388891
2 Material
Spraying angle
2 Material
Spray pattern
3 Tip nut
Spray pattern
3 Air cap 4 Fan air
GM 2800EA
19