Introduction - Teledyne T102 Operation Manual

1. INTRODUCTION

The information contained in this addendum is pertinent to T102 analyzers running
software revision G.4. Some or all of the information may not be applicable to
07267B DCN6485
previous revision of that software.
This addendum is based on the Model T101 Operators Manual (PN 07266). In most
ways the T102 is identical to the T101 in design and operation; therefore most of the
basic set up information, operating instructions as well as calibration, maintenance,
troubleshooting and repair methods are found in that manual.
This addendum documents only those areas where the T102 is different in design or
operating method from the T101.
Specifically:
Areas where updates and improvements to the Model T10X software
•
have been implemented since the publication date of the T101 Manual -
PN 07266.
EXTERNAL TRS CONVERSION: Like the T101, which converts H
•
SO then measures the amount of SO
2,
technique, the T102 converts total reduced sulfur (TRS) gases into SO
before measuring the SO
Unlike the T101, which performs the H
requires an external
Therefore this addendum includes instructions and information regarding:
• Areas of operation and setup of the T102 that depart from the
method described by the T101 operator's manual due to the TRS 
SO2 conversion being performed externally.
The proper setup and operation on the M501-TRS.
•
NOTE
present using a UV fluorescence
2
using the same UV fluorescence method.
2
S  SO
2
TRS converter, in
conversion internally, the T102
2
this case a TAPI
S to
2
2
M501-TRS.
13