Preparations Before Filling; Filling The Machine - Wexiodisk WD-12 Installation And User Manual

Instructions for use

4.1.2 Preparations before filling

Numbers in brackets refer to the diagram in the chapter "The machine's design".
Check:
•
•
•
•
•
•
Washing-up liquid must not be used in the machine or for pre-treating items
(soaking, pre-washing, etc.). Washing-up liquid causes a build-up of foam, pro-
duces poor wash results and can damage the machine.
Fit:
The level pipe (12), pump filters (14), strainers (18) and strainer plates (19). The
rubber seal of the level pipe (13) must be sealed against the bottom plate.
Depending on the items to be washed, the grid shelf (11) (option) may need to be
folded down when washing heavily soiled loads.

4.1.3 Filling the machine

Numbers in brackets refer to the diagram in the chapter "The machine's design".
•
•
•
•
WD-12
that the power switch is in the ON position.
that the dishwasher and all removable components are cleaned, if not
clean!
that there is no dirt in the nozzles in the washing and rinsing arms (10, 17).
that the level pipe seal (13) is undamaged.
that the shut-off cock for the water is open.
the amount of detergent and drying agent.
Switch on the power using the 0/1 button (9). Close the hood by pressing
button (5). The display (2) shows the temperature of the rinsing water. The
display (4) shows P0. P0 is a pause mode which indicates that no washing
programme has been selected.
Filling and heating for a standard machine take approx. 20 minutes at an
incoming water temperature of 55° C. The heating time is dependent on the
incoming water temperature.
When the machine has filled up, the symbol (1) lights up and the washing
temperature is shown in the display (2). If the washing temperature falls be-
low the set value by more than 5°C, the temperature shown on the display
(2) flashes.
The machine cannot start washing until the set temperature minus 5°C for
the washing water has been reached, if this function is selected. The nor-
mal operating temperature for the washing phase is 60° C. If the washing
temperature falls below 50° C, the temperature display flashes.
30
Rev. 2.0 (201706)