Table of Contents
Advertisement
Operating instructions
4.1.2 Preparations before filling
Check and fit:
•
•
•
•
•
•
•
•
Remember:
•
•
•
•
•
•
4.1.3 Filling and heating the machine
•
•
•
•
WD-8
That the machine and removable parts have been cleaned. If not – clean
them!
That no dirt is in the wash arms' (17) or in the rinse pipes' nozzles
That removable parts are correctly in place
That the rubber sleeve (14) is undamaged
Amount of detergent and drying agent (option)
That the stopcock for the water to the machine is open
That the machine hood is closed
That the power switch is in the ON position
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable
detergent. Washing-up liquid causes a build-up of foam, produces poor
wash results and can damage the machine.
Steel wool must not be used for pre-treating the dishware.
Only detergent and drying agent intended for industrial machines may be
used.
If using liquid detergent and drying agent, the same make and type of
detergent and drying agent should be used.
If the machine is designed for glass washing and equipped with a
condensing unit, detergent intended for aluminium should be used.
If the machine is equipped with a condensing unit, dishware should be
removed from the machine as soon as the condensation cycle is complete
so that re-condensation does not occur.
Switch on the power using the 0/1 button (9) on the panel. The display (3)
shows the temperature of the rinsing water. The display (4) shows "P0". P0
is a pause mode which indicates that no washing programme has been
selected.
Filling will begin once the hood is closed. Filling and heating for a standard
machine takes approx. 6 minutes at an incoming water temperature of
55°C. The heating time is dependent on the incoming water temperature.
Once the machine is full, the symbol (1) lights up and the display (2) shows
the temperature of the washing water. If the washing temperature falls
below the set value by more than 5° C, the temperature shown on the
display (2) flashes.
The machine cannot start washing until the set temperature minus 5°C for
the washing water has been reached, if this function is selected. The
normal operating temperature for the washing phase is 60°C. When the
washing temperature falls below 50°C, the temperature display flashes.
32
Rev. 4.0 (202202)
Advertisement
Table of Contents
