Table of Contents
Advertisement
Installation
3.4 Installation
3.4.1 Preparing for the installation
3.4.2 Positioning the machine
Check that there is sufficient room for the dishwasher at the installation location.
Check that there are correct connections for water, electricity and a waste pipe at
the installation location.
Check that the overheating protection device is reset.
Check the following points before the machine is placed in position:
•
Check that the fuse for the machine at the site is off and non-live.
•
Remove the protective plastic on the sides which are to be stood against a
wall.
•
If holes need to be drilled in the machine, the holes must be fitted with an
edge strip or similar protection.
•
Put the machine in position and check that it is horizontal using a spirit lev-
el. Use the legs to adjust machine height. Once the machine has been filled
with water, do another check to make sure the machine is standing level.
•
If the machine is to be corner-loaded, it must be positioned with the control
panel furthest away from the wall.
•
Adjust the height using the machine's legs. The machine can also be fitted
with extension legs (35mm).
WD-12
12
Rev. 2.0 (201706)
Hide quick links:
Advertisement
Table of Contents
